Technical

Edge Profiles Available
Square
Pencil
Rolled
Bullnose
Half Bullnose
Laminated to 60mm for all of the above
Mitred to various thickness's in Square edge and pencil Edge

Joins and Various Finishes available
Because Granite and Marble is not man-made some Benchtops will require joins, we don't use more joins than we need and place them in the least obvious positions possible. Joins are kept as small as practical generally around 2mm and we level all the granite to make the transition frm one piece to the other as smooth as possible. The joins are filled with specified granite epoxy glue and normally coloured to suit the granite or marble being used.

Two finishes are available, The most popular is the fully polished surface, which is achieved by using various grades of diamonds and water to achieve a mirror finish both Granite and marble are in their most sealed natural state when fully polished

Honed finish as exactly as above but only 3/4 polished give a flat soft matt surface, thus meaning the Granite or Marble is in a less sealed state than it would be if fully polished

Sink mounting options 
Top-mount - Most economical option where by the bowl is fitted on top of the granite, resulting in a raised lip around the surface
 
Flush-mount - The flange of the bowl is recessed down into the stone until it is flush with the surface
 
Under-mount - The bowl hole is cut out and fully polished around the edge the bowl is then mounted underneath the granite leaving the top surface of the stone clear and uninterupted by a stainless flange
 
Recess Under-mount - THe exact same process as under-mount and finished by rebating out the underside of the cut-out resulting in the bowl being lifted toward the surface by appoximately 15,mm.
 
Semi  Recessed  cut-outs - Most comonly used with vanity basins where the bowl is exposed past the front of the granite or when a butler sink is being used in the kitchen